Refer to how to make No-Melt Snowballs Project first before attempting the snowman!

Shopping List

• 1 - Tube Crystal Glitter Gold Ultra Fine
• 1 - pkg. Each of Dress It UP Buttons: "Winter Weather", "Color Me Black", "Snowflakes"
• 1/4 yard of Warm & White Batting
• 1 - 3" Styrofoam Ball
• 1 - 4" Styrofoam Ball
• 1 - 5" Styrofoam Ball
• 1 - pkg. Polly Pellets
• 1 - 8oz. Aleene's Tacky Glue
• 1 - pkg. Sculpey Clay - Sweet Potato
• 2 - Small tree twigs for arms
• 1 - Tub of Delta Snow
• 1 - Flannel Fat Quarter
• 1 - 1/8" x 36" wooden dowel rod
• Wire cutters
• Scissors & Pinking Sheers
• Steak Knife
• Gloves
• 2 plastic cups
• Stiff Brush
• Paper Towels & Waxed Paper
• Needle Thread
• Pencil

Instructions

1. Trim enough off the bottom of the 5" Styrofoam ball with steak knife so it will stand on its own without rolling.
2. Flatten the top of the 5" Styrofoam ball.
3. Flatten the top & bottom of the 4" Styrofoam ball (mid-section of snowman).
4. Flatten one end of the 3" Styrofoam ball (head).
5. Cut wooden dowel rod with wire cutter in two - 3" pieces.
6. With tacky glue apply glue to each end of dowel rod.
7. Then apply tacky glue to top of the flattened 5" Styrofoam ball.
8. Press the dowel rod down through center of flattened area, leaving about 1