|
Breast Cancer Awareness Bracelet |
|
Shopping List
- 1 Antique Silver Clasp “Tierra Cast”
- 2 crimp tubes silver 2x2mm
- 1 pack of Antique Silver 4mm Rocco spacers 10pc “Tierra Cast” (4-RS)
- 1 pack of Awareness Ribbons 4pc “Tierra Cast”
- 1 strand of 4mm Bi-cones Lt. Rose Swarovski 50pc (4-BC)
- 1 pack of 4mm Squaredelles Rose 4pc (4-SQ)
- 4 6mm Bi-cones Rose Swarovski (6-BC)
- 1 strand 4mm Cubes Rose Swarovski 16pc (4-CU)
- 10” piece of Beading Wire
Basic Supplies
- Crimp Pliers
- Side Cutters
|
|
Instructions
- Begin by sliding one crimp tube onto your beading wire then one 4mm crystal and one end of closure, turn and thread wire back through the 4mm crystal and crimp tube, use crimp pliers to close and secure.
- This is your stringing pattern: (see Supply list for abbreviations) 4-BC, 4-CU, 4-BC, 4-CU, 4-SQ, 4CU, 4BC, ribbon charm, 4-CU, 4-BC, 4-RS, 6-BC, 4-RS, 4-BC, 4-CU, 4-BC, 4-CU, 4-SQ, 4-CU, 4-BC, ribbon charm, 4-CU, 4-BC, 4-RS, 6-BC, 4-RS, 4-BC, 4-CU, 4-BC, 4-CU, 4-SQ, 4-CU, 4-BC, ribbon charm, 4-CU, 4-BC, 4-RS, 6-BC, 4-RS, 4-BC, 4-CU, 4-BC, 4-CU, 4-SQ, 4-CU, 4-BC, ribbon charm, 4-CU, 4-BC, 4-RS, 6-BC, 4-RS, 4-BC, crimp tube, 4-BC, and other end of closure.
- Turn and run wire back through the 4mm bi-cone and crimp tube, then crimp to secure. Trim off excess wire to finish.
|
|
|
|
|
|
|
