Supplies

• 18"  20 gauge sterling silver wire
• 1 Large focal bead drilled through

Directions

1. Using the round nosed pliers, take the piece of 20 gauge wire and make a decorative loop.
2. Slide the focal bead onto the wire.
3. Wrap the wire around the bead in an overlapping pattern. Leave about 2 inches of wire unwrapped as a "tail" . Do not press the tail against the bead. The wire will be easier to coil if it sticks out from the bead.
4. Using the round nosed pliers make a closed loop on the end of the wire.
5. Pinch the flat side of the loop between the blades of a chain nosed pliers. Use the pliers to wind the wire around the closed loop. Wind as many layers as you like. Press the coil to the bead. You're done!